Psp go screws

Does not include the display.

Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides. Open the back cover by gently lifting the right side, and rotating it to the left side as if you were opening a book. Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device. Unscrew the lone Phillips screw holding the trigger in place. Remove both trigger and retaining plate from the PSP Go. Do not peel the sticker away from the left EMI shield. Use the plastic opening tool to gently peel away at the "Warranty Void" sticker.

Psp go screws

.

Case Components 9. I assume this is the case, but just wanted to be sure.

.

Does not include the display. Clear all filters. Item Type. Batteries 1. Buttons 9. Cables 1. Case Components 9. Display Components 2.

Psp go screws

Try adjusting your search or filter to find what you're looking for. Upgrade what's not. It's fast, easy, and safe to replace your screen , battery , joystick , buttons , case and more. Item Type: Screws and Bolts. Item Type. Antennas 2. Batteries 8.

Seeing shadows in vision

During reassembly, make sure to properly line up the power button with the power button lever on the logic board. To save you the frustration, we ensure that our products are fully tested. Be very careful that you wedge it in the same location shown in the first picture. The front panel should now be free from the metal frame. To reassemble your device, follow these instructions in reverse order. Remove both headphone jack and analog joystick screws using your 00 Phillips screwdriver. Do not peel the sticker away from the left EMI shield. Rotate the display degrees and free the bottom side of the display in the same manner. Trust us to equip you for success with every repair endeavor! When putting a new battery into the PSP Go, make sure you hold the "Warranty Sticker" so you don't put the battery on top of it.

Complete repair manual for the PSP Go, including battery upgrade and display repair instructions. PSP Go. These are some common tools used to work on this device.

The logic board is still connected to the display, so do not fully remove it from its housing! Slide the plastic opening tool around the perimeter of the display, increasing the gap between the metal frame and the front panel. Motherboards 1. Use a plastic opening tool to pop out the battery, being careful not to snag the "Warranty Void" sticker in the process. When putting a new battery into the PSP Go, make sure you hold the "Warranty Sticker" so you don't put the battery on top of it. Do not peel the sticker away from the left EMI shield. Remove both headphone jack and analog joystick screws using your 00 Phillips screwdriver. Step 2. Cancel: I did not complete this guide. Make sure to grasp the black plastic pull tab of the cable. Device Type. Unplug the volume button cable using a pair of tweezers. Tool Category. You're Finished!